Clarke-tech VBOX V4000 Instrukcja Użytkownika

V4000 * DiSEqC 1.2 Positioner & Standalone Positioner * Compatible with all DiSEqC 1.2 Receivers * 6 Digits Display * 60 Pre

To reset the system: If you want to clear everything stored in the positioner, including high/low limits and satellite positions, reset the syst

To store the satellite positions: 1. After the DiSEqC1.2 receiver moves the actuator and stores the satellite position, the display will automatical

Troubleshooting The Memorized Positions are not correct. • First, try re-sync to correct the position. • If the symptom recurs repeatedly, replac

Safety Precautions WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT OPEN THE POSITIONER OR REMOVE THE TOP COVER. TO PREVENT FIRE OR ELECTRI

Introduction VBOX is a 2-in-1, full-function antenna positioner for motorized satellite antenna systems. It can work as a traditional, DiSEqC1

Remote Control Receiver Type Remote Control Positions Note No 99 Fully controlled by receiver. DiSEqC 1.2 Yes/Optional 99 Controlled by r

Cable Connection Setting up the positioner: 1. Connect the 4-wire cable between VBOX positioner and the actuator. Connect the motor to the ter

Operation as Standalone Positioner Setting the software high/low limits: There are hardware limit switches in the actuators or H-H mounts to

ons to the proper position. Press the Store key for 2 seconds: the LED will flash and show ”C--_ _” and “STORE” alternately. Press number keys

buttons. Then type in the name using the number buttons (1~9). 4. Press the OK key. The name that you choose will flash three times, then the assigne

Recall saved satellite position: With the following procedure, you can move the dish to any stored position. 1. Using the number keys on the remote,